Trade Mortar 20kg

Pre-Mixed Masonry Mortar, AS 3700 Class M4

Introduction

MERCOL Trade Mortar is a factory-blended masonry mortar supplied in 20kg bags. Each batch consists of graded sand, high-grade binders, oxide and performance additives. Mercol ready to use mortar is independently tested to AS 3700 Class M4. Just add clean water to mix and use.

 

The product is manufactured to the same specification as the mortar supplied through MERCOL’s automated silo systems on multi-storey commercial developments, packaged for applications where bulk material cannot be used or where volumes do not warrant a silo.

 

The range is available in 38 colours, including Absolute Black (the blackest mortar available in Australia) and is delivered throughout Victoria, South Australia, New South Wales and Queensland.

Colour Range – 38 Factory-Matched Colours

Colour consistency in site-mixed mortar depends on manual oxide dosing and varies between mixes, operators and even the day/time it is blended. MERCOL colours are dosed and blended under factory control, so the exact shade is maintained across bags, pallets and production runs. This is a determining factor on projects where the mortar joint is an architectural element rather than a structural necessity: raked joints on dark facades, contrast pointing, heritage matching and detailed architectural blockwork.

 

Absolute Black is the darkest mortar in the range. Pigmented mortars marketed as black commonly cure to a charcoal or blue-grey tone. Absolute Black is formulated to retain depth of colour through cure, and is specified where a lighter joint would reduce contrast against dark face brick.

PropertyValue
Bag weight20kg
Mortar classAS 3700 Class M4 — independently tested
Coverage50 bags for 700 standard wire cut bricks
Yield1 ton = 0.7 cubic metres of wet mortar
Water addition2.5 litres per 20kg bag (guide only – individual preference)
Working time1 – 1.5 hours at 20°C
Compressive strength12-14 MPa at 28 days
Shelf life6 -10 months, unopened, dry storage
Pallet quantity50 bags per pallet
Colour range38 colours, including Absolute Black
DistributionVictoria, South Australia, New South Wales, Queensland

Product Characteristics

On-site-mixed mortar is manually calculated and is therefore subject to quite a lot of variation in binder ratio, water content and hydration. This variation can present as inconsistent bond strength and unpredictable durability performance, typically identified after construction is complete. The major issue with on-site mixing comes when an architect has specified a particular mortar colour and the colour consistency is critical to the finished face. Factory pre-mixing removes the variations from the site process.

MERCOL mixes are formulated in consultation with practising bricklayers and assessed for workability as well as strength.

Applications

MERCOL Trade Mortar is specified for:

  • face brickwork and detailed masonry
  • blockwork
  • pointing and repointing
  • heritage and repair work requiring colour matching
  • luxury residential construction
  • constrained and inner-urban sites where bulk material cannot be staged

Bagged Product and Silo Supply

 20kg BagsAutomated Silo
ApplicationDetail work, repairs, constrained sites, colour-critical workSustained-volume commercial and multi-storey construction
Site setupNone — delivered palletisedSilo delivered and positioned on site
HandlingManual, 20kg unitsAutomated dispensing; no manual lifting
Colour consistencyFactory-batchedFactory-batched
Mortar classAS 3700 Class M4AS 3700 Class M4
Material lossOpened as requiredDispensed as required

Both supply formats deliver mortar to the same specification. Projects with sustained daily consumption generally achieve lower labour cost and reduced manual handling exposure through silo supply.

→ Compare Silo Systems

Technical and Ordering Information

Does MERCOL Trade Mortar comply with AS 3700?

Yes, across the entire 20kg range. All our mortar (including our coloured mortar) is tested and certified to AS 3700 Class M4, the highest durability classification in the standard. Test certificates are available on request for your QA documentation.

The premium oxides are measured and blended under factory control, maintaining colour consistency between bags, pallets and production runs. For large orders we recommend advising the total brick or block quantity upfront so that the oxide can be pre-purchased and put aside.

Under AS 3700, M4 is the higher durability classification, specified for severe exposure conditions including marine environments and applications below damp-proof course in aggressive soils. M3 applies to general wetting and drying exposure. MERCOL supplies M4 as standard.

M4 is specified for the most severe exposure conditions under AS 3700 — including marine and highly exposed environments. Because MERCOL supplies certified M4, you’re covered for those conditions without changing product mid-build. Always work to the project specification and your engineer’s direction.

As a rule of thumb, approximately 3 bags per m² of standard brickwork at 10mm joints. Our technical team can work with you to provide estimates based on size of bricks or blocks.

No. MERCOL 20kg pre-mixed mortar bags contain graded sand, binders and additives in the correct proportions. Add clean water only. DO NOT ADD LIME.

Yes. We produce coloured mortar to specification and hold the formulation so repeat orders and future maintenance work matches the original. We have 38 colours available, with 5 colours standard in stock (see our Colour Chart for easy reference). 

6 – 10 months shelf life, unopened in dry storage.

MERCOL delivers throughout Victoria, South Australia, New South Wales and Queensland. MERCOL has a 250 bag (5 ton) minimum order quantity for our wide range of coloured & grey mortars.

Custom blends and colour matching to an existing joint or supplied sample are available. We can custom blend a special order on request (minimum order quantity for custom matched mortar is 5 tonnes (250 bags) and there is a custom match fee of $150 per sample.)

Check out our Builders Guide for more information: Mortar Mix Ratio’s Explained.

Ordering

Trade pricing, pallet quantities and delivery scheduling are available for Victoria, South Australia, New South Wales and Queensland.

 

How much do the 20kg bags cost?

MERCOL 20kg pre-mixed mortar bags are available in 38 different colour options and a standard grey mortar. Because of the difference in oxide and cement costs some colours may cost more than others.

Contact our Technical Consultants for more information on pricing.

 

Is delivery included in the price?

No. Each order is individually quoted based on the number of bags or pallets and the delivery address. Weekend deliveries incur a surcharge and need to be requested in advance.

Contact Mercol on 1300 637 265 for technical support, colour matching and specification assistance.